522-2501 CHEMLIFE® 24 PLUS Neutral CV Pigmented Primer

CHEMLIFE 24 PLUS Neutral Primer is designed for hardwoods and MDF. This product offers excellent filling properties as well as excellent vertical hang.

Substrate should be sanded using 120, 150 or 180 grit stearated paper. CHEMLIFE 24 PLUS Neutral Primer cannot be used on metal, old oil or cellulose lacquers. Suitable topcoats are CHEMLIFE 24 PLUS White 117-25XX or CHEMLIFE 24 PLUS Clear 117-26XX.

Mix CHEMLIFE 24 PLUS Neutral Primer thoroughly, then catalyze and reduce material as recommended. CHEMLIFE 24 PLUS Neutral Primer must be well mixed while adding catalyst and reducers and must be agitated at all times to ensure product consistency.

CHEMLIFE 24 PLUS Neutral Primer is applied in one or two coats and can be used as a primer for most wood and wood products meant for indoor use. A thorough sanding using 240/320 grit stearated paper between coats is essential for adhesion. The second and subsequent coats must be applied the same day as the previous coat is sanded. Care should be taken to avoid sanding through the primer coat. With profiled edges, care must be taken with sanding of primer to avoid sanding through sharp edges. Complex profiles or profiles with sharp corners may cause difficulties in obtaining an effective primer coat of even thickness. In these cases, profile design must be discussed with your technical representative. Contact with metal surfaces should be avoided once the CHEMLIFE 24 PLUS Neutral Primer has been catalyzed. To ensure proper uniformity, the material should be agitated at all times. Recommended film build of Chemlife 24 Plus Neutral Primer is not to exceed 4 mils dry. Total recommended film build of CHEMLIFE 24 PLUS Neutral Primer and CHEMLIFE 24 PLUS Topcoat is not to exceed 6 mils dry.

CHEMLIFE 24 PLUS Neutral Primer must not be polluted with oil, varnish or the like and must not be sanded with steel wool between the coats. CHEMLIFE 24 PLUS Neutral Primer must not be used and dried at temperatures below 18°C or relative humidity above 65%. During the curing process, the coating must not be exposed to ammonia vapors. Ammonia cleaners should not be used for cleaning the finish surfaces. This may accelerate discoloration.