131-51XX ES Lacquer White Pre-Cat Pigmented Topcoat

The material is used to achieve an open or semi-open grain finish on all types of wood for interior use. To augment the chemical resistance of the product, E.S. Lacquer 131-51XX may be catalyzed.

Wood substrate should be sanded with 120, 150 or 180 grit paper prior to staining or coating. Sealers should be sanded with 280/320 grit stearated paper prior to topcoating. The sealer should be topcoated within eight hours of sanding. When recoating, the previous coat of E.S. Lacquer must be sanded and the next coat applied within eight hours. E.S. Lacquer cannot be used on metal, old oil or cellulose lacquer.

Agitate material before use. Always mix E.S. Lacquer while adding hardener and reducers in the recommended mixing ratios. E.S. Lacquer must be agitated thoroughly at all times to ensure product consistency and consistent gloss.

Apply at 3-5 mils wet on sanded substrate. Further coats may be applied after complete drying followed by sanding with 280/320 grit stearated paper.

Maximum film build of E.S. Lacquer should not exceed 4 mils dry. Maximum film build of total coating system must not exceed 4 mils dry. To obtain a complete cure, the system should be applied at an ambient temperature above 18ºC and a relative humidity below 65%. When drying, this product is not to be exposed to ammonia vapors. Finished surfaces must not be cleaned with ammonia containing products.

Basecoats to use with 131-51XX: 225-0010, 522-1624, 545-8016, 546-7257 or self-seal